8.
Install injection pump, observing marked in‐
stallation position.
9.
Install securing screws of injection pump and tighten with torque wrench to the specified torque.
Name
Size
Type
Lubricant
Value/Standard
Securing screw
Tightening torque
60 Nm + 12 Nm
10.
Install fuel line (2).
11.
Tighten union nut on the injection pump to the specified tightening torque using a torque wrench.
• Maximum permissible tightening torque: 35 Nm
Name
Size
Type
Lubricant
Value/Standard
Union nut
Tightening torque
20 Nm + 5 Nm
12.
Tighten union nut on the pressure-tube connection piece to the specified tightening torque using a torque
wrench.
• Maximum permissible tightening torque: 35 Nm
Name
Size
Type
Lubricant
Value/Standard
Union nut
Tightening torque
20 Nm + 5 Nm
13.
Install injection pump cabling (1).
14.
Use torque wrench to tighten screws to the specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
Tightening torque
1.0 Nm ± 0.2 Nm
Final steps
1.
Remove barring device (→ Page 104).
2.
Clean mating faces on cylinder head and charge-air manifold.
3.
Check seals for damage and replace them, if required.
4.
Coat seals with grease (Kluthe Hakuform 30-10/Emulgier) and place onto cylinder head.
5.
Install charge-air pipes.
6.
Install Engine Control System (→ Page 178).
7.
Open fuel supply line before fuel filter.
8.
Vent fuel system (→ Page 131).
122 | Task Description | MS150031/03E 2011-10
TIM-ID: 0000004579 - 002
Summary of Contents for 12 V 2000 M40A
