6
INM9469-3
June 2012
10 MAINTENANCE & TROUBLESHOOTING
The module is provided with LED indicators to assist in recognising possible fault conditions.
Refer to the following table for assistance in interpreting LED activity.
OFF
FLASH
ON
PWR
(green)
Power fail
N/A
Power OK
WLAN
(yellow)
Idle
Wireless LAN
data activity
N/A
STAT
(red)
AP mode = Normal
status
–
Fault
Bridge mode =
connection to AP is
established
Bridge mode =
attempting to
connect to AP
ACT
(yellow)
Ethernet link
disconnected
Ethernet link
activity
Ethernet link
connected
100
(green)
Ethernet link set to
10Mbps
N/A
Ethernet link is
100Mbps
11 ENVIRONMENTAL
Operating Temperature
–20°C…+60°C
Storage Temperature
–20°C…+60°C
Humidity
5…95% RH, non condensing
12 WASTE REMOVAL INFORMATION
The electronic equipment within must not be treated as general waste. By ensuring
that this product is disposed of correctly you will be helping to prevent potentially
negative consequences for the environment and human health, which could otherwise
be caused by incorrect waste handling of this product.
For more detailed information about the take-back and recycling contact
MTL
.
13 TECHNICAL
Ethernet LAN
RJ45 10/100 Base TX Interface
WiFi
IEEE 802.11a/b/g/h 2.4 / 5 / 5.4 GHz standards, multi-country Roaming support (IEEE
802.11d). Dynamic Frequency Selection (DFS) support provides flexible selection of best frequency
to allow mobility among all existing IEEE 802.11a/b/g/h networks; “ClearVoice” band provides
non-overlapping channels for fast-speed data transmission; Transmission Power Control (TPC) offers
flexibility to adjust RF output power.
Data Rate
Up to 108Mbps (Super AG mode)
Channels
13 channels (b/g modes), 8 channels (a mode), 11 channels (h mode)
Output Power
Trans20dBm (TPC)
Sensitivity
Receiver –92dBm for IEEE 802.11a/g and –95dBm for IEEE 802.11b
Modulation
OFDM: BPSK, QPSK, 16QAM, 64QAM DSSS: DBPSK, DQPSK, CCK
