M.T.H. HO 4-8-2 Mohawk Steam Engine
3
QUICK START GUIDE
Of course, you should read your manual over before running your
Mohawk. But if you just can’t wait, choose how you want to run below and
enjoy!! Now, after a few minutes, shut her down and read through your
engineer’s guide.
I USE A REGULAR DC SUPPLY…
Step 1: Unpack your Mohawk. (refer to unpacking instruction on pg 4)…
Step 2: Set the engine on the track …
Step 3: Apply increasing
DC
voltage until she starts up and pulls out!
I'M A DCC OPERATOR….
Step 1: Unpack your Mohawk. (refer to unpacking instructions on pg 4)…
Step 2: Set the engine on the track …
Step 3: Power up your DCC system…
Step 4: Select engine address 3 and press “F3” to start her up…
Step 5: Turn the throttle and head on down the pike…
I RUN DCS….
Step 1: Unpack your Mohawk. (refer to unpacking instructions on pg 4)…
Step 2:
Set the engine on the track …
Step 3:
Power up your DCS system…
Step 4:
Add the engine to your system and start her up…
Step 5:
Turn the throttle and move out….
CAUTION:
M.T.H. HO engines
DO NOT OPERATE ON AC VOLTAGE
.
Applying AC power to your locomotive could cause permanent damage and will
void your warranty.
