EN - 27
◆
Display Information
Press the or (<0.5s) button and select Display Info, then press the (<0.5s) but- ton to read
the software and hardware data in the display. To Exit press the (<0.5s
) button, once “EXIT” is
highlighted to return to the information settings.
◆
Torque Information
Press the or (<0.5s
) button and select “Torque info”, then press the (<0.5
s) button to read
the software and hardware data in the display. To Exit press the (<0.5s
) button, once “EXIT” is
highlighted to return to the information settings.
◆
Error Code
Press the or (<0.5s
) button and select “Error Code”, and then press the
(<0.5s) button to
confirm. It shows error information for the last ten errors of the pedelec.
Error code "00"means that there is no error. To return to the menu press the (<0.5s) button, once
"BACK" is highlighted to return to the information settings.
◆
ERROR CODE DEFINITION
The display can show the errors of a pedelec. If an error is detected, the wrench icon appears on
the display and one of the following error codes will be displayed. Please read the description of
the error code carefully. If you see the error code, restart the system first. If the problem is not
resolved, please contact your dealer.
Error
Declaration
Troubleshooting
10
The temperature inside the engine has
reached its maximum protection value.
Turn off the system and allow the Pedelec to
cool down.
14
The temperature inside the controller has
reached its maximum protection value.
Turn off the system and allow the Pedelec to
cool down.
21
Speed sensor Error
Restart the system
Check that the magnet attached to the spoke is
aligned with the speed sensor and that the
distance is between 10 mm and 20 mm. Check
that the speed sensor connector is connected
correctly.
If the error persists, please contact your retailer.
If an error code is displayed, have the problem corrected. Otherwise you will not be able to ride the e-
bike normally. Always contact an authorized bicycle dealer.
Beware of safe use. Do not attempt to loosen or reconnect the connector while charging the battery or
while the battery power is on.
Avoid the risk of electric shock.
Do not subject the display to shocks.
Do not modify system parameters to avoid parameter mismatch.
