2
NOTE: If the tire pressure is not equal in both tires, the
unit may pull to one side or the other during operation.
2.
CHUTE INSTALLATION
2.1.
Apply a light lubricant to the rim/lip of the chute
base (and the underside of the chute assembly)
and position the chute over the base.
2.2.
Close the flange keepers to secure the chute to
the base. See Figure 3.
NOTE:
If the flange keepers will not easily click
into place, use the palm of your hand to apply
swift, firm pressure to the back of each.
3.
DISCHARGE CHUTE REMOVAL
3.1.
To remove the discharge chute, use the blade-
side of a screwdriver by wedging between the
housing and the flange keepers and with a lifting
and prying motion lift the locking flange out of
the locked position and pivot the flange keepers
outwards.
3.2.
Lift the chute assembly off the mounting base of
the main housing.
4.
DIRECTIONAL CONTROL ASSEMBLY
4.1.
Remove the flat washer and hairpin clip from the
end of the chute directional control.
4.2.
Insert the end of the chute directional control into
the lower bracket and secure with the flat
washer and hairpin clip. See Figure 4.
5.
CHUTE BRACKET ADJUSTMENT
If necessary the Chute Bracket can be adjusted if the
spiral at the bottom of the directional control is not fully
engaging the chute assembly.
5.1.
Loosen the two nuts, which secure the chute
bracket and reposition it slightly before retighten-
ing the nuts. See Figure 5.
6.
SKID SHOE AND SHAVE PLATE ADJUST-
MENT
The space between the shave plate and the ground
can be adjusted.
For close snow removal on a smooth surface, raise
skid shoes higher on the auger housing to lower the
shave plate.
Figure 3
Third flange keeper is at front of chute
Open flange keeper
Closed flange keeper
Figure 4
Directional Control Lever
Hairpin Clip Washer
Figure 5
Adjustment Nuts
