5
When replacing pins, spray an oil lubricant into shaft
before inserting new pins.
10.
SHIFT ROD ADJUSTMENT
If the full range of speeds (forward and reverse) cannot
be achieved, adjust the shift rod.
10.1. Place the shift lever in the fastest forward speed
position and remove the hairpin clip which
secures the ferrule to the shift lever. See Figure
11.
10.2. Rotate the shift arm clockwise as far as it will go.
10.3. Thread the ferrule up or down the shift rod until it
aligns with the hole in the shift lever.
10.4. Re-secure the ferrule with the hairpin clip
removed earlier.
11.
AUGER BELT REPLACEMENT
Figure 11
Lower portion of shift lever
Ferrule Shift Rod
Hairpin Clip
Figure 12
Rotate Clockwise (Down)
Shift Arm
11.1. Using a 3/8” socket and extension, remove the
two self-tapping screws securing the plastic belt
cover to the frame. See Figure 13.
11.2. Drain the gasoline from the snow thrower, or
place a piece of plastic under the gas cap
11.3. Disconnect the spark plug wire from the spark
plug. See Figure 14.
11.4. Carefully pivot the snow thrower up and forward
so that it rests on the auger housing.
Figure 13
Self Tapping Screw - (Other one is on the right side)
Figure 14
Plastic under gas cap Spark Plug Wire
