2019-2020
Delight Service Manual
Visit our website at: www.the-mspa.com
- 7 -
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface
3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
NOTE:
Glue is not included. Aquaseal & Stormsure glue is recommended for PVC inflatable items.
Glue physical and technical information:
2.6 Using Spa in the Cold Weather
It’s only possible to set up and leave the spa in the environment of outside temperature of less than 4°C as long as the
spa has a constant water temperature guaranteed over 4°C.
Spa can only be used for temperature down to maximum
-10°C if it is properly set up to make sure no frozen water inside control box, pipes and spa pool.
Optional accessories:
B9300109N/B9300492N Heat Preservation Mat is helpful to avoid heat loss from bottom and it
provides better heat insulation results.
Inflatable bladder provides better heat preservation and rain outflow.
2.7 Temperature issue
If customer asks about temperature display on the control panel cannot reach to the set temperature of 40
℃
(Maximum) and it indicates 38
℃
, 39
℃
, 40
℃
and 41
℃
, we may explain to the consumer that it is normal to show a
minor difference from the actual temperature to the rate displays on the control panel. It’s normal with a 1-2
℃
gap.
2.8 Broken zipper issue
Regarding broken zipper complaint, first check if the air pressure is within the normal range. Over-inflated spa liner
could damage the spa cover zipper.
A replaced top lid may not 100% fit onto the spa pool. 3-4cm (1-2”) difference is common. Because there might be a
little zipper length difference between the new top lid or spa liner and the used ones. To avoid zipper claim, please
recommend the customer to maintain the zipper by waxing it regularly.
In case of broken zipper on liners, we’d suggest the new buckle cover with ground mat for service support:
