2-24
Hardware Setup
▍
MS-S0101
CompactFlash Slot
Ths CompactFlash slot shares one channel of the IDE controller and supports
one CompactFlash type I / type II devce.
Important
The CF1 slot and the IDE1 connector shares and uses the same channel. CF1
and IDE1 can support up to 2 IDE devices without CF device or 1 IDE device
with 1 CF device.
If you install two IDE devices, you must configure the second drive to Slave
mode by setting its jumper. Refer to the hard disk documentation supplied by
hard disk vendors for jumper setting instructions.
If you install one CF device and one IDE device with ATA133 IDE cable, you
must configure the CF drive to Master mode by setting jumper JCF_SEL1.
CF only supports
Master mode by using ATA133 IDE cable. CF only supports
Slave mode by using ATA33 IDE cable.
•
•
•
