MSI LT VALVE TECHNICAL MANUAL
Revision D
April 03, 2014
56
13.
Install the insert
o-rings (8)
into the
insert (7)
grooves and coat with
grease to retain the rings.
14.
Make sure the entire sealing surface is thoroughly greased.
15.
Apply a thin film of grease to the entire I.D. of the
insert set
(7)
.
16.
Place the
inserts (7)
around the
plug (6)
in the
valve body (1)
making
sure it slides into the roll pins.
17.
Apply thread compound (Never-Seez) to the
adjusting nut (12)
threads and
adjusting nut
(12)
sealing surfaces.
18.
Grease the
seal ring (10)
groove and insert the
o ring (9)
.
19.
Place the
seal ring
(
10)
on the top of the
inserts
(7)
.
20.
Install the
adjusting nut (12)
into the
valve body (1)
and tighten until
snug and back off ¼ turn from the snug position.
21.
Apply thread compound (Never Seez) grease to the
plug bolt
(
14)
threads
and tighten it with the allen wrench on the
adjusting nut (12)
side of the
plug (6)
.
22.
Apply thread compound (Never Seez) to the threads on the
SafeTap™
grease fitting (2)
. Install grease fittings and torque to 80 ft-lbs.
NOTE: Do not use Teflon tape on the grease fitting.
23.
Remove excess grease from valve bore.
24.
Inspect plug alignment and adjust as necessary with
adjusting nut (12)
.
25.
Apply Removable Threadlocker (blue) in the threads of the stud end and
screw the
studs (3)
until tight. Screw the
nuts (4)
over the
studs (3)
Note: Do not use Red High Strength Threadlocker.
