MSH equipment WIZARD UP 30, Operating Instructions Manual

Page: 24 / 42

Wizard Up30 Rev. 4 28/04/2017
23
7. FIRST OPERATION
Be sure the platforms are fully closed before getting on/off the lift. Get in the vehicle and drive on the lift; be sure the
vehicle is centred and both rear and front wheels are properly positioned, place the proper rubber pads on the
platform
(pic. 14) so that they are in line with the lifting points specified by the manufacturer.
Press the “lifting” button, keep it pressed until the required height is reached. To lower the lift, press the “lowering”
button
(pic.4 - pos.2) .
During the lowering phase, the lift will stop at about 400 mm height; start it again, release the lowering button and then
press it again; from this position as far as complete closing, the lift will produce a safety acoustic signal.
During the first hours of operation cracking noises could occur. This is due to the natural settlement of
mechanical parts and will disappear during the following hours of operation.
CHECKS
Perform the following checks when operating the car lift:
Carefully check the car lift and its load during lifting/lowering operation.
Check the warning acoustic signal operation of the car lift during lowering phase.
ATTENTION: When the lift is operating, the max pressure in the hydraulic pipes is 300 bar.
Pic. 14