15
Exemplary drawing.
Air supply requirements
•
Supply tool with a maximum pressure according to the technical data of this unit of clean,
dry air. Higher pressure drastically reduces tool life and/or can cause several injury.
•
Connect tool to air line using pipe, hose and fitting sizes shown in the diagram above.
•
Do not install a quick coupler directly into the air tool handle.
•
In order to have the tool working to full satisfaction the minimum air delivery must be at
least 10% higher than the indicated air consumption of the air tool.
•
Please consult the technical data in this instruction manual.
Instruction of use
•
Please make sure that if the tool is fitted with a torque/air regulator, that the torque
achieved complies with the application.
•
If an extra support handle is supplied with the tool, make sure that it will be fitted before
the tool is used and hold, if possible, the tool with two hands.
Lubrication
•
Use an air line lubricator with oil, adjusted to two (2) drops per minute. If an air line
lubricator cannot be used, then once a days 1 or 2 drops special (SAE10) air motor oil
needs to be added into the air inlet.
