MSG MS012 COM, Operation Manual

Page: 8 / 88

English
tester MS012 COM
6
• CALIBRATION : button to enter the tester calibration menu. This menu is meant exclusively for
calibration of the device by specialists from the manufacturing facility.
WARNING! Customers are not allowed to make any changes to the tester calibration.
Current software version is displayed in the bottom right corner of menu screen SETTINGS.
The resistance value of the simulated rotor, displayed below buttons
12V and 24V , is set with
adjustment knob EL LOAD in the following range:
•
from 1.8 to 22 Ohm for 12V;
• from 4.1 to 22 Ohm for 24V.
Press button 12V or 24V to enter the menu for selection of the voltage regulator type (Fig.6
and 7):
Figure 6 – Menu to select the type of the tested voltage regulator
with nominal voltage of 12V
Figure 7 – Menu to select the type of the tested voltage regulator
with nominal voltage of 24V