INSTALLATION INSTRUCTIONS
AUTOTRONIC CONTROLS CORPORATION
• 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
REV LIMITER
This Ignition features a built-in Soft Touch Rev Control with two different rpm limits. The Soft Touch
circuitry provides a smooth and accurate rev limit by dropping the spark to individual cylinders.
The Soft Touch produces a load-free rev limit that is within 1% of the selected rpm.
You can select two rev limits; one for a low limit that can be used when staging the car, and
another limit for top end overrev protection. Both rpm limits are adjusted in 100 rpm increments
with the sealed rotary switches on the side of the ignition. Using and programming the Two Step
is explained in detail on page 6.
RETARD CONTROL
There is a single stage of retard that can be adjusted from 0 to 9.9 degrees in 1/10° increments.
The retard is activated when the Pink wire receives 12 volts which is explained on page 6.
START RETARD
To ease starting on engines with locked out timing, there is a Start Retard circuit. When set, the
timing will be retarded 20° until the engine reaches over 800 rpm. Activating the Start Retard is
done with the Cylinder Select dial and is explained on page 5.
CYLINDER SELECT
The MSD is programmed at the factory for use on 8-cylinder engines. If you are installing it to a
different engine you will have to program the Ignition. This is easily achieved through the cylinder
select switch on the side of the ignition. Page 5 outlines setting the cylinder select.
GENERAl INFORMATION
BATTERY
An MSD 6 Series Ignition Control will operate on any negative ground, 12 volt electrical system
with a distributor. The MSD can be used with 16 volt batteries and can withstand a momentary 24
volts in case of jump starts. The Ignition will deliver full voltage with a supply of 9 - 18 volts and
will operate with a supply voltage as low as six volts.
If your application does not use an alternator, allow at least 15 amp/hour for every half hour of
operation. The MSD uses about .7 Amps for every 1,000 rpm. If the engine is cranked with the
same battery or other accessories such as an electric fuel or water pump are used, the amp/hour
rating should be higher.
COILS
The MSD Digital 6 Plus Ignition can be used with most stock coils and aftermarket coils designed
to replace the stock coils. The line of MSD Blaster Coils are great for street and mild racing. For
extended high rpm operation the Blaster HVC, PN 8252 is recommended. For more information
on recommended coils, consult the supplied Coil Application Chart or check with our Customer
Service Department at (915) 855-7123.
Figure 1 Tach Terminal
TACHOMETERS
The MSD Ignition features a Tach Output Terminal on the side of the
unit (Figure 1). This terminal provides a trigger signal for tachometers,
a shift light or other add-on rpm activated devices. The Tach Output
Terminal produces a 12 volt square wave signal with a 30° duty
cycle.
Some vehicles with factory tachometers may require a Tach Adapter
to operate with the MSD. For more information on Tachometers and
MSD Tach Adapters, see the Tachometer Section on page 8.
If your GM vehicle has an inline filter it may cause the tach to drop
to zero on acceleration. If this occurs, bypass the filter.
