•
The choice is confirmed by pressing the <ACK/VALID>
button or rejected by pressing the <ESC/TEST> button.
To Access the Code <CodE> Mode:
1.
Select <CodE> and press the <ACK/VALID> button.
•
The Password Code is listed.
2.
Press the <ACK/VALID> button to change the code.
3.
Use the <SCROLL UP> and <SCROLL DOWN> buttons to
set the new Factory Mode Password.
NOTE: Enter the new user mode password in the same
manner as the password was input to access the
user mode.
•
The choice is confirmed by pressing the <ACK/VALID>
button or rejected by pressing the <ESC/TEST> button.
To Access the List <LISt> Mode:
1.
Select <LISt> and press the <ACK/VALID> button.
•
This command sends all of the channel settings and the
current state of the monitor to the printer for printing in the
language selected.
•
run appears on the display during printing.
To Exit User <USEr> Mode:
1.
Press the <ESC/TEST> button until the software tree is exited
and the unit returns to measure mode.
System Checks
There are two system checks available through the front panel
keypad (FIGURE 3-1). The two checks are:
•
Lamp test
•
Configuration review.
Performing a Lamp Test:
1.
Press the <SCROLL UP> button (also indicated with a lamp
diagram) while in the measure mode.
Chapter 3, Start-up and Operation
3-15
