CABLE AND BATTERY COVER
ASSEMBLY
Replacing the Cable
1. To separate the headpiece, cable
and cover, remove battery cover
clamp screws, one on each side,
and slide cover clamps off side-
ways. Lift cover to permit access
to cable clamp screws, loosen
them, and carefully pry cable
clamps off the battery poles.
2. To separate the cable from the
cover, remove cable retaining
screws and washers, then lift the
cable away from the circular boss-
es molded in the cover and pull the
cable through the cable protector.
3. Lubricate approximately 6” length
of other end of new cable with
soapy water and insert it into the
cover by pushing each terminated
conductor, one at a time, through
the cable protector.
Continue pushing cable until 3-1/4”
of cable sheath is exposed inside
the cover. Wrap cable around and
through circular bosses molded in
the cover and press firmly to inside
top of cover. Secure in place by
assembling cable retaining wash-
ers and screws.
4. Clean any foreign matter from
each battery pole.
5. Fasten red conductor to positive
battery pole and black conductor
to negative pole to insure correct
polarity.
Tighten in a position so that cover
will sit squarely on battery top.
6. Slide on cover clamps.
Lock in place with cover clamp
screws.
TAL 998 (L) Rev. 2 - 817184
9
Cable and Battery Cover Assembly
817184 8/13/99 9:43 AM Page 9
