4. Turn the headpiece downward and
carefully shake reflector into palm
of your hand.
5. While facing headpiece, make sure
that the focusing knob has been
rotated to its extreme clockwise
position.
6. Place a new reflector into position
in the headpiece so that the two
pins extending from its yoke drop
into the slots of the metal bushing.
7. While applying a slight pressure
against the reflector edge with fin-
gers, draw the reflector inward by
rotating the focusing knob counter-
clockwise to its full stop position.
Reflector may be damaged if it is
not drawn back to its extreme stop
position within the headpiece
before the bezel is attached and
tightened.
8. Insert bulb and replace the bezel
assembly.
Replacing Cable
1. To separate the headpiece, cable
and cover, remove battery cover
clamp screws, one on each side.
Slide cover clamps off sideways.
Lift cover to permit access to
cable clamp screws, loosen them,
and carefully pry cable clamps off
the battery poles.
2. To separate the cable from the
cover, remove cable retaining
screws and washers, then lift the
cable away from the circular boss-
es molded in the cover and pull the
cable through the cable protector.
3. To separate the headpiece from
the cable, use 5/64” hexagon
wrench and remove three screws
from each side and the top of the
stainless steel clip.
Slide cap hook back along cable.
Lift rubber flap on the cable end at
the top rear of headpiece and
remove headpiece cable screws.
4. Remove cap hook from cable to
be replaced and slide it on the
new cable.
12
TAL 998 (L) Rev. 2 - 817184
Maintenance
CAUTION
817184 8/13/99 9:44 AM Page 14