MrCool Signature MAC16 A Series Installation Manual Download Page 10

507043-04C

Page 9 of 9

mrcool.com

Homeowner’s Information

Important System Information

Your system should never be operated without a clean 

Return air and supply air registers should be free from 

Regular Maintenance Requirements

service  technician.  These  regular  visits  may  include 

(among other things) checks for:

Motor operation

Ductwork air leaks

Coil & drain pan cleanliness (indoor and outdoor)

Electrical component operation & wiring check

Proper refrigerant level & refrigerant leaks

Drainage of condensate

Blower wheel alignment, balance & cleaning

Primary & secondary drain line cleanliness

Proper defrost operation (heat pumps)

There is some routine maintenance procedures you can do 

to help keep your system operating at peak performance 

between visits.

Air Filter

common cause of poor heating/cooling performance and 

compressor failures.

Indoor Coil

it should require minimal cleaning. Use a vacuum cleaner 

and soft brush attachment to remove any accumulation of 

However, perform this maintenance only when the coil is 

completely dry.

If  the  coil  cannot  be  cleaned  by  this  method,  call  your 

dealer for service. It may need a detergent solution and 

rinsing  with  water  for  cleaning,  which  may  require  coil 

removal, You should not attempt this yourself.

Condensate Drain

of drainage and clean if necessary.

Condenser Coils

Grass cuttings, leaves, dirt, dust, lint from clothes dryers, 

and fall off trees can be drawn into coils by movement of 

your unit and cause damage to the condenser.

Periodically, debris should be brushed from the condenser 

coils.

SHARP OBJECT HAZARD!

Condenser  coils  have  sharp  edges.  Wear  adequate 

body protection on body extremities (e.g. gloves).

FAILURE  TO  FOLLOW  THIS  WARNING  COULD 

RESULT IN BODILY INJURY.

 WARNING

Use a soft brush with light pressure only. DO NOT damage 

affect unit operation.

Painted Surfaces

of  automobile  wax  should  be  applied  every  year.  In 

geographical areas where water has a high concentration 

of minerals (calcium, iron, sulfur, etc.), it is recommended 

that  lawn  sprinklers  not  be  allowed  to  spray  the  unit.  In 

such applications, the sprinklers should be directed away 

from the unit. Failure to follow this precaution may result 

components.

In sea coast areas, special maintenance is required due 

to  the  corrosive  atmosphere  provided  by  the  high  salt 

concentration in ocean mists and the air. Periodic washing 

of all exposed surfaces and coil will add additional life to 

your unit. Please consult your installing dealer for proper 

procedures in your geographic area.

IF  YOUR  SYSTEM  DOES  NOT  WORK,  BEFORE 

REQUESTING A SERVICE CALL:

1. Ensure  thermostat  is  set  below  (cooling)  or  above 

(heating) room temperature and that the system lever 

is in the “COOL,” “HEAT” or “AUTO” position.

2.

conditioner may not function properly.

3. Check  indoor  and  outdoor  disconnect  switches. 

blown. Reset breakers/replace fuses as necessary.

4. Inspect  the  outdoor  unit  for  clogged  condenser 

coils,(grass cuttings, leaves, dirt, dust or lint). Ensure 

that branches, twigs or other debris are not obstructing 

the condenser fan.

IF  YOUR  SYSTEM  STILL  DOES  NOT  OPERATE, 

CONTACT YOUR SERVICING DEALER.

Be sure to describe the problem, and have the model and 

serial numbers of the equipment available.

If warranted replacement parts are required, the warranty 

Summary of Contents for Signature MAC16 A Series












Reviews: