29
Set Function / Range Switch to desired
•
A or
•
V range.
Set the clamp Meter into the " PEAK HOLD " mode by
pushing the "YELLOW" button. The LCD will display " P+ P- ".
Press the “PEAK” button to enter PEAK mode. LCD
will display “P+ MAX” or “P- MIN”. The “PEAK” button
is toggle selector the P+ and P- value.
Press the “PEAK” button for two seconds to exit the PEAK
mode.
Follow this procedure for AC Voltage and current measurement.
The displayed reading is the positive peak value or negative
peak value of a surge in current or a voltage transient pulse.
Because the surge transient pulse is usually asymmetric.
5-9 Operation Of Data Record And Read
Singly Data Record
The clamp meter can store 25 data record in memory.
Once the button is pressed, the data number and
RECORD symbol will be shown on LCD. If the memory is
full, the FULL signal will be shown on LCD when the record
button is pressed.
Singly Data Record
Press “Yellow” button until the READ symbol shown on LCD, then
Press “
•
” button to read previous data. Press “
•
” button to read
next data. Press “Yellow” button again to exit.
Continue Data Record
The full memory size got 4000 records. To start recording
data, press the RECORD button until 2 “beep” sounds
heard and “RECORD” symbol will be shown on LCD. To
stop recording data, press the RECORD button again until
the RECORD symbol disappears.
Continue Data Record
With the connection of RS-232 interface & computer P.C.
software.
