- 4 -
1.9 Over low alarm lamp and knob
2.Operation Manual
1.
POWER
1.1 Check the working voltage is □110V/60Hz or □220/50Hz
1.2 After confirming the working voltage is correct, insert the power cord to socket
1.3 Turn on the power, the present temperature will display on the temperature control; PV is the
actual temperature of inner box; SV is the set temperature
1.4 Humidity
1.5 Turn on the DEFROST switch at the upper right side of the incubator.
2.
COOLER r
Auto. Time-delay 6-7 min. compressor running, every 6 hour automatically power cut to eliminate
mildrew For 6 min. then re-start.(if over low protection start to bounce back, accompanying with alarm
at the same time, after that, automatically delay for 6 min. then re-start running.
3.
DAY TEMPERATURE CONTROL
3.1 Setting temperat
ure : First to press the key of “
＜
”, the “SV” key will be in flashing, then start to set
the temperature. The monitor of “SV” will be in high light, then set the required temperature at the
position of high light. To press the key of shift left “►”, the position of high light will be moved
accordingly.
3.2 To press the key of shift up “▲”, the temperature will go up;
To press the key of shift down “▼”, the temperature will go down
3.3 When complete the temperature setting, the “SV” key is still in flashing, need to press the key of
“SET” again, the setting temperature will be on the “SV”
(“PV”) is the actual temperature .
3.4.The heating light of “ Out” is in light , it means the machine is in heating , the light of “OUT” in flash
mean it arrives the required temperature and is normal condition .
4.
HUMIDITY CONTROL
Check water bath having water or not , then automatically refill water , setting humidity.Please use RO
water or distilled water
