- 16 -
2.
ELECTRIC WIRE:
Please do not use too thin diameter of extensive wire due to it will cause the voltage
goes down. It must use the sole-wire or specification extensive wire to protect the machine works
normal and last longer.
3. VOLTAGE:
Please make sure the voltage is normal before using the machine because the compressor
might be damage cause by the unstable voltage.
4. The machine must install on a flat ground, due to the rough surface might cause the noise.
5. Please avoid over 45
- angle slope when remove the machine. Cause the over 45
angle slope might
damage the function of refrigerated system. If it over 45
- angle slope on remove machine, you could
only use it after
2 – 4 hours
or more to protect the Compressor.
6. On settle the machine, it must remain more than 30cm to the wall, 20cm on two side. The temp. must
below 30
C could protect the Compressor and make it function efficiently.
7. Do not put the machine on a
too humidity
place, due to the
humidity
will cause the Constant Temp.
Machine FROSTED, short circuit, corrode the outer-shell and inefficient the Compressor.
8. Please avoid settle the machine close to other heater machine, sunshiny directly or on a hermetical and
high temp. place
9. Please do use the connected ground wire to avoid any caution occur.
10. Please
turn off the power
when not use the machine and open the door for 2 –3 days to dryer inside
could make the spare part have longer lasting.
