MRA 4025066156955, Mounting Instructions

Page: 3 / 8

3
GB
MOUNTING INSTRUCTIONS
Honda CB500F 16-
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number Article Article No.. Required tools
1 MRA windshield --- Allen key 3mm, 5mm
1 Couple of retaining plates 11170
4 Fillister head screw M5 x 16mm 10554
4 Plastic washers 12 x 5mm 10635
4 Rubber nuts M5 10629
1 Edge protection with clamping
sleeves ---
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the left original Allen screw (P 1) to subsequently remount the left plate with
it. Do the same on the right hand-side. Make sure not to confound the left and the
right plate. Don’t tighten the retaining screws yet.
Do not remove the retaining screws and the headlight casing simultaneously as
the lamp casing might collapse forward.
3. When both retaining plates are mounted as shown in picture 2, insert the rubber nuts
into the holding plates and mount the MRS windshield using the M5x16 fillister head
screws and the plastic washers.
4. Now align the MRA windshield with the vehicle and tighten the M5x16 fillister head
screws and the original retaining plate fastening screws.
5. Pull on the edge protection profile as shown in picture 3. If applicable, cut off the rest.
6. Slide the clamping sleeves over the ends of the edge protection profile and slightly
press them together with combination pliers so that the edge protection profile is
clamped.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de