mr
.
steam
steambaths
®
tempo controls
29
Installing the Remote Temperature Probe
for Tempo & Tempo/Plus Controls
(PN: MSTS)
The Remote Temperature Probe is required when the Tempo
™
or Tempo/Plus
™
Controls are installed outside the steam room.
The Remote Temperature Probe (P/N MSTS) is for use
with Tempo™ and Tempo/Plus™ Controls only. Do not use any other con-
trols. Do not use any other temperature probe with the Tempo™ or
Tempo/Plus™ controls. Noncompatible products may result in an inoperative
control and a hazardous condition.
Install the Tempo
™
or Tempo/Plus
™
Controls according to
the installation and operation instructions supplied with the Controls.
Failure to do so may result in an inoperative control and a hazardous condi-
tion.
1. Determine the location of the Remote Temperature Probe:
The Remote Temperature Probe must be installed:
1. On a vertical surface
2. 4-5 feet above the floor
3. Away from the steam head
4. Not exposed to direct steam emission.
The probe has an integral 30' cable. Insure that
the probe and/or steam generator are located
accordingly. Contact a MrSteam technical service
representative if a longer cable is required.
2. Drill a 5/16 inch diameter hole in the wall as
shown in Diagram 1. Do not oversize or under-
size the hole. Clean area thoroughly.
3. Remove the knock-out from the steam generator
jacket as shown in Diagram 2.
4. Insert the remote temperature probe cable
through the knock-out and connect to the con-
nector onthe steam generator printed circuit
board marked "TEMP PROBE"as shown in
Diagram 2.
NOTE: FOR ILLUSTRATIVE PURPOSES ONLY.
Consult with qualified designer, architect or
contractor for steam room construction details.
DRAWING NOT TO SCALE
!
C A U T I O N
!
C A U T I O N
Mad
e in
USA
Model:
kW
Volts
Phase
Amps
Hz
Printed Circuit Board
Component shown for
illustrative purpose
MrSteam Steam Generator
(shown with cover removed and NOT installed)
Knock-Out
Temperature
Sensing Probe
Temperature
Probe Cable
(30 feet)
Temperature Probe
Connection
DIAGRAM 1
DIAGRAM 2