13
800-852-4263
BOT
TL
IN
G
&
C
ARB
O
N
AT
IN
G
1. When your beer is ready to bottle, fill a 1-gallon container with warm water, then add the remaining ½ pack of the No-Rinse
Cleanser and stir until dissolved. Once dissolved, it is ready to use.
2. Distribute the sanitizing solution equally among the bottles. Screw on caps and shake bottles vigorously. Allow to sit 10
minutes, then shake the bottles again. Remove caps
16
and empty all sanitizing solution into a large bowl. Use this solution to
sanitize any other equipment you may be using for bottling. Do not rinse.
3. Add 2 carbonation drops to each 740-mL bottle. For 1-liter bottles, add 2½ drops; for ½-liter bottles add, 1 drop. For other
bottle sizes see: http://www.mrbeer.com/help.
17
4. Holding the bottle at an angle, fill each bottle to about 2 inches from the bottle’s top.
18
5. Place caps on bottles, hand tighten, and gently turn the bottle over to check the bottle’s seal. It is not necessary to shake them.
&
1. When your beer is ready to bottle, pour one entire pack of
No-Rinse Cleanser into 8 liters (2 gallons) of water and stir until
dissolved. Once dissolved, it is ready to use.
2. Distribute the sanitizing solution equally among the bottles. Screw on caps and shake bottles vigorously. Allow to sit 10
minutes, then shake the bottles again. Remove caps
16
and empty all sanitizing solution into a large bowl. Use this solution to
sanitize any other equipment you may be using for bottling. Do not rinse.
3. Add 2 carbonation drops to each 740-mL bottle. For 1-liter bottles, add 2½ drops; for ½-liter bottles, add 1 drop. For other
bottle sizes see: http://www.mrbeer.com/help.
17
4. With your included bottling wand, insert the bottling wand into the spigot tap. Slide the bottling wand into the bottle and
allow beer to flow through by pushing the bottle up against the bottling wand’s check valve.
5. Fill each bottle to the top. When the wand is removed from the bottle, it will provide proper head space.
6. Place caps on bottles, hand tighten, and then gently turn the bottle over to check the bottle’s seal. It is not necessary to shake
them.
