MQ Power WHISPERWATT DCA-180SSV, Operation And Parts Manual

Page: 28 / 84

PAGE 28 — DCA-180SSV— OPERATION AND PARTS MANUAL — REV. #1 (04/14/10)
DCA-180SSV — GENERATOR OUTPUTS
Generator Amperage
Tables 8 and 9 describe the generator’s current output capa-
bility for both 1Ø-phase and 3Ø phase applications.
e l b a li a v A s e g a t l o V . 7 e l b a T
e s a h P e e r h T
) e l b a h c t i w S (
V 8 0 2 V 0 2 2 V 0 4 2 V 6 1 4 V 0 4 4 V 0 8 4
e s a h P e l g n i S
) e l b a h c t i w S (
V 0 2 1 V 7 2 1 V 9 3 1 V 0 4 2 V 4 5 2 V 7 7 2
Generator Output Voltages
A wide range of voltages are available to supply voltage for
many different applications. Voltages are selected by apply-
ing jumpers (6) to the
voltage change-over board
(Figure 14).
To obtain some of the voltages as listed in Table 6 (see
below) will require a fine adjustment using the
voltage regu-
lator (VR) control knob located on the control panel.
Voltage Change-Over Board
The voltage change-over board (Figure 14) is located on
the control box, behind the generator control panel. This
board has been provided for ease of voltage selection.
CAUTION - CHANGING VOLTAGES
NEVER attempt to place jumper plates on the voltage
change-over board
while the generator is in operation.
There exist the possibility of electrocution, electrical
shock or burn, which can cause severe bodily harm
or even death
!
Figure 14. Voltage Change-Over Board
s g n i t a R e r e p m A r o t a r e n e G . 8 e l b a T
⎯ ⎯ ⎯ ⎯ ⎯
1
∅ ∅ ∅ ∅ ∅
W k V 0 2 1 V 0 4 2
8 1 0 5 1 5 7
8 3 6 1 3 8 5 1
8 5 3 8 4 7 6 2
8 7 0 5 6 6 3 2
8 9 7 1 8 2 9 4
8 1 1 3 8 9 9 1 3
8 3 1 0 5 1 , 1 5 7 5
) x a M ( 8 5 1 7 1 3 , 1 8 5 6
s g n i t a R e r e p m A r o t a r e n e G . 9 e l b a T
⎯ ⎯ ⎯ ⎯ ⎯
3
∅ ∅ ∅ ∅ ∅
A V K V 0 4 2 V 0 8 4
0 2 8 4 4 2
0 4 6 9 8 4
0 6 4 4 1 2 7
0 8 2 9 1 6 9
0 0 1 1 4 2 0 2 1
0 2 1 9 8 2 4 4 1
0 4 1 7 3 3 8 6 1
0 6 1 4 8 3 2 9 1
) x a M ( 0 8 1 3 3 4 6 1 2