MPMan FRAL501, Instruction Manual

Page: 6 / 44

EN
G
LIS
H
5
BATTERY BACK-UP
(For Temporary Time Storage Only)
Install 2 x LR06, AA or EU-3 battery (not included) according to polarity shown
inside the battery compartment. In the event of a power interruption, your set
will not work normally from the mains supply but there is now the advantage that
your clock will continue to work. The clock display will not light up, as the clock
time will be held in the memory. This also enables you to move the set from place
to place without re-setting the clock every time. The battery back-up system is
only meant to be used from short temporary power interruption. For longer
durations, the battery may become exhausted or there may be some deviation in
accuracy. When the battery is exhausted, it should be removed from the set to
prevent leakage. If you do not wish to take advantage of the battery back-up
system, your set will work normally without a battery. However, if disconnected
from the mains, the clock gures will ash when the mains are re-connected and
you must re-set the clock as described in the Electronic Clock Operation
paragraph.
Attention should be drawn to the environmental aspects of battery disposal. Don't
throw used batteries in dustbin. Please contact your retailer in order to protect
the environment.
Attention should be drawn to the environmental aspects of battery disposal.
Electrical products should not be disposal of with household waste. Please recycle
where facilities exist. Check with your Local Authority of retailer for recycling
device.
(Batteries pack or batteries installed) shall not be exposed to excessive heat such
as sunshine, re or the like.
SPECIFICATION
Power Source : 230V ~50Hz
Tuner Range : FM 87.5-108.0MHz
Power Consumption : 5W
Product information is subject to change without prior notice.
This is to certify that FRAL501 is in conformity with:
Council directive 89/336/EEC (EMC direction):
Applicable standards:
EN55013:2001+A1:2003+A2:2006
EN61000-3-2:2006+A1:2009+A2:2009
EN61000-3-3:2008
EN55020:2007
Made in PRC
For more information please visit our website
www.mpmaneurope.com