hood, make the opening for the flue pipe in the shelf, with a minimum
diameter of 140 mm.
2.
Remove the aluminium fat filter (Fig.8).
3.
Place the hood in the assembly place, mark the places for openings in
the cabinet bottom, remove the hood and drill the openings Ø2 for the
screws.
4.
The hood assembly is shown at the drawing (Fig.9); for this purpose,
prepare four wood screws which shall be shorter than the thickness of
the screwed element (e.g., for hood assembly to the cabinet made of 18
mm wood chip board, the 16 mm screw shall be used). Place accurately
the hoof under the cabinet, hold the hood with one hand, or ask one
more person for help, then screw in the screws on their places.
5.
Mount the filter as shown at the Fig. 8, in the reverse order.
Hood assembly to the wall:
1.
Define the axis of cooking range, and project it onto the wall, where the
hood will be mounted. Sign all characteristic points of hood fastening.
Make the openings with the drill. (Fig.10 )
2.
Into the openings, insert the screw plugs. In two openings marked with
A screw also the screws (leaving 7 mm of screw length outside the
screw plug, Fig.11).
3.
Remove the aluminium fat filter (Fig.8).
4.
Hang the hood on two untightened screws (Fig. 12).
5.
Place the level on the hood body. Rotating the element marked with
A,
adjust the hood level according the level’s indications, and then tighten
two screws previously screwed partially and screw in two remaining
screws).
6.
Mount the filter as shown at the Fig. 8, in the reverse order.
