18
EN
Each attachment is appropriately marked in the middle outer sur-
face. Always install the attachment before starting the device and
turn the device off in order to change the attachment.
To install the attachment, hold it with the blade teeth and place it
on the blade, then press the back of the attachment until you will
hear a click.
To remove the attachment, unhook the back of the attachment
and pull it off the blade.
To ensure a smooth cutting, guide the attachment evenly through
hair. Do not push it too quickly and remember to remove cut hair
and check that the hair strands are even.
ADJUSTMENT OF BLADES
1.
Remove the protective cap of blades (7).
2.
Hair clippers are carefully checked for lubrication and the adjust-
ment of blades.
3.
Blades must be readjusted after the removal for cleaning and re-
placement.
4.
Adjustment of blades is connected with
the setting of teeth (upper and lower
blade) – the tip of the upper blade tooth
should be set back in relation to the low-
er blade by approx. 1.2 mm – see Fig-
ure 1.
5.
If the position of blades is incorrect, add a few
drops of the oil and turn on the hair clipper for a
while. Loosen bolts and adjust. Then tighten bolts
– see Figure 2.
Figure 1
Figure 2
Summary of Contents for MMW-02
