MPB SEP, User Manual

Page: 33 / 48

USER MANUAL
S E M S
- 33 -
otherwise the value will be zero. Under the “Shown Values” command, there is the
“Standard” field: by default the software will select “Flat Selectable Limit”, giving the
user an additional control to define the amplitude limit. Moreover, the “Limit” tab can
show on the graph the limits required by the different ongoing standards. By default,
the software allows to load four different standards:

ICNIRP 2010 General Public

ICNIRP 2010 Occupational

Italy CM 2003 Attention Value

Italy CM 2003 Exposure Limits
The values obtained can be printed in the three following units of measure:

V/m

W/
𝑚
2

Mw/
𝑐𝑚
2

% (percentage value related to the limit according to the frequency)
The values will be updated at the end of the scansion. Moreover, the values can be
shown ordered by “Frequency” or “Amplitude” only by clicking on the preferred label
button. The “Limit” tab allows the user to export the measured values in .csv, and a
commodity form to calculate the conformity reduction factors.
Figure 28 Conformity