Moyer Diebel DFM7, Installation Manual

Page: 16 / 50

8
Operation
Assembling the Glasswasher
1. Make sure the power switch is in the OFF position.
2. Install the wash arms and rinse spray arms. The spray arms have locating notches
in the end of each arm. Push the spray arm straight into the hub. Do not twist.
3. Install the conveyor assembly as follows:
Insert the conveyor into the wash chamber keeping the rear raised.
Pull the conveyor forward until it meshes with the drive gear located at the front
of the wash chamber.
Continue to pull the conveyor forward as you lower it on the pivot.
4. Install the stainless steel cylinder in the center of the conveyor.
5. Install the conveyor shut-off assembly (plexiglass divider).
6. Install the right and left hand tray.
7. Install the curtain assembly.
8. Install the upper and lower scrap screens.
9. Install the standpipe in the detergent tank.
Twist slightly to make sure it seats securely in the drain.
9. Install the drain tray/waste collector (if equipped).
Make sure the drain fitting is secure.
10. Make sure the chemical supply containers are full.
11.
Close the door.
Filling the Wash Tank
1. Ensure that the overflow/drain tube is in place in the detergent tank.
2. Flip power on-off/flush switch to the “ON” position. The water will
fill until the proper water level is reached.
3. The water temperature is controlled by a tank heater and an
adjustable thermostat. The thermostat should be set for a
minimum of 140°F/60°C.
Operating Instructions
1. Ensure that chemical supply containers are full.
2. Detergent is fed into the detergent in controlled amounts
detergent dispensing pump. Use detergent at a strength
recommended by your chemical supplier.
3. Open the front door and flip the on/off/flush switch to the
“ON” position. The detergent tank will fill automatically.
4. Load glasses on the conveyor. The conveyor will stop
when the glasses contact the conveyor shut-off switch.
Operation
(continued)