Moxa Technologies NPort Server Lite DE-302, Hardware Installation Manual

Page: 13 / 33

2-5
The next step is to attach NPort Server Lite to the Din Rail.
STEP 1: Insert the top of the DIN Rail
into slot A of the DIN Rail
mount.
STEP 2: Push the bottom of NPort
Server Lite so that the bottom
of the DIN Rail snaps into
slot B of the DIN Rail mount.
To remove NPort Server Lite from the DIN Rail, simply reverse Steps 2 and 3
above by grasping the bottom of the NPort Express device server with both
hands, and then using your fingers to pull down slightly on the DIN Rail mounts
at slot B. This releases the bottom of the DIN Rail from the DIN Rail mount.
Network Connection
There are two ways to use the 10/100BaseT Ethernet jack located on NPort
Server Lite’s rear panel.
1. For many of the applications using NPort Server Lite, you will simply plug
one end of your Ethernet cable into the 10/100BaseT jack, and the other end
into the hub connected to your network. In this case, use a standard
straight-through Ethernet cable.
2. In some cases, such as when configuring drivers and software, you will find
it convenient to hook NPort Server Lite directly to your computer’s Ethernet
card. To do this you will need to use a cross-over Ethernet cable, such as the
one supplied with your server.