Software Installation
Smartio
C168H/HS User’s Manual
3-25
Please select one of the following OSs:
1.
SCO UNIX
2.
UNIX SVR4.2
Select :
Please select one of the devices where the driver diskette/files put:
1.
/dev/fd0135ds18
(A: 1.44MB )
2.
/dev/fd096ds15
(A: 1.2 MB
)
3.
/dev/fd1135ds18
(B: 1.44MB )
4.
/dev/fd196ds15
(B: 1.2 MB
)
5.
Hard Disk
/tmp/moxa
Select :
Then the
MOXA Multiport Board Installation Utility
will show for
board installation.
Choose
C168 Series driver
and follow the instructions to install.
Step 6.
Configure the board by,
#
moxaadm
The moxaadm utility is used to tell the UNIX driver how many Smatio
C168 Series boards are installed, what their basic setting (I/O or IRQ), etc.
It is also used to remove the
Smartio
C168 Series UNIX driver from the
system. Whenever the setting is changed, run this utility again and tell the
UNIX driver what is changed. Refer to section “
Administration Utility-
moxaadm
” for more information.
This utility is not intended to change the
Smartio
C168 Series
“hardware” I/O address nor IRQ setting. If you need to change the
Smartio
C168 Series hardware IRQ, for example, you need to execute
IO-IRQ utility under DOS environment. The IO-IRQ utility is contained
in the Dos/Windows3.x driver diskette.
Only up to two
Smartio
C168 Series boards are allowed to be installed
under UNIX systems when MOXA UNIX driver is used.