CAN Interface Board User’s Manual
CAN Interface Board Utility
The MxCANTool parameters for each CAN controller can be configured during an MxCANTool
Setup session.
Parameter Options
Description
Device [Board...]
Board 0…
Board 3
Displays boards in the system.
Select the CAN interface board to configure
Device [Controller…]
Controller 0
Controller 1
Displays controllers in the board.
Select the controller to configure.
10K bits/sec…
1000K
bits/sec…
Select a regular Baud Rate.
Baud Rate
User Defined
If User defined is selected need to configure the
BTR0/BTR1 parameters.
BTR0/BTR1(Hex)
0x00-0xFF
To set a user-defined Baudrate, refer to the datasheet
of NXP SJA1000 in section 6.5.
Open/Close
Open/Close CAN controller.
ACC Code
(Acceptance Code)
0-FFFFFFFF
Set the parameter to allow the specified ID frame to be
received.
Refer to the
cnio_set_filter_ex
function from Library
reference for detail.
ACC Mask
(Acceptance Mask)
0-FFFFFFFF
Set the parameter to mask the specified bit in frame to
be received.
Refer to
cnio_set_filter_ex
function from Library
reference for detail.
Start/Stop
Set to Operation mode/Reset mode.
4-2
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-9622-Moxa-CP-602U-I.aspx
