Movincool Office Pro 10, Service Manual

Page: 52 / 56

TROUBLESHOOTING AND REPAIR
44
COMPRESSOR
NUT
STEEL
WASHER
CUSHION
STEEL
COLLAR
Compressor Mounting
Evaporator Blower Assembly
Condenser Blower Assembly
Reassemble the unit in the reverse order of removal.
Described below are the parts that require special
care in reassembling the unit. Perform all wiring or
rewiring as referenced in the wiring diagram.
30. Compressor Mounting
Mount the compressor on the frame, using
cushions, steel collars, steel washers and nuts.
31. Blower and Condenser Motor Assembly
a. Install blower fan (for evaporator) and
condenser fan.
Tightening torque:
1.10
± 0.22 lbf•ft (15.5 ± 3.0 kgf•cm)
32. Wiring Notice
Secure the wires using clamps so that they do
not come into contact with the edges of the
structure, etc. Secure the wires using clamps in
the same position they were before removal.
33. Perform the inspection of cooling capacity
and check for abnormal noise or abnormal
vibration.
NOTE: Casters should roll and swivel freely.
Check for dirt or dust build up. Remove dust or
dirt build up.