Movincool Office Pro 10, Service Manual, Page: 13 / 56

CONSTRUCTION, SPECIFICATIONS, and DATA
5
2. Air Flow
Air is drawn from the intake ducts then passes
through the condenser which extracts the heat.
This hot air is blown out through the exhaust air
duct. Air taken in from the rear face is cooled by
the evaporator and then blown through the cool
air vent. All the air inlets are equipped with filters,
while the exhaust air outlet is protected by wire
mesh.
3. Compressor and Fans
The compressor is hermetically sealed. A two-
speed fan motor is used with centrifugal (back-
ward impeller) fans to draw air across the evapo-
rator. The condenser fan draws air over the
condenser section.
4. Drain Tank
The capacity of the drain tank is approximately
3.0 gallons (11 liters). The unit is equipped with a
“Tank Full” LED and a device to automatically
stop the operation of the unit when the drain tank
reaches a level of approximately 3.0 gallons (11
liters).
5. Condensate Pump (Optional)
The condensate pump will pump water from the
pump’s main tank to a nearby sink or floor drain.
The pump will lift the water a vertical distance of
18 feet. A plastic hose is supplied with the pump.
It is important that the drain line from the pump is
not kinked or bent.
EVAPORATOR
AIR IN
COOL
AIR OUT
CONDENSER
AIR IN
EXHAUST
AIR OUT
Condenser / Exhaust Air Flow
Air Flow