Movement Wire Crossover, User Manual

Page: 52 / 127

ASSEMBLY
5
10
CAUTION!
Before starting the installation of the equipment it is necessary to pay attention to the following precautions:
•
Make sure that the packaging is not damaged and that the parts and components of the equipment are not damaged.
•
It is recommended that the equipment be unpacked at the place where it will be assembled.
•
The assembly area should be clean.
•
The floor must be level, firm and hard to prevent equipment instability.
•
The area around the equipment must be free as described in this Manual (see the chapter Discovering the equipment).
•
It is recommended that the equipment be mounted away from moisture and away from sunlight in order to avoid damaging
the electronic parts of the equipment.
•
Make sure there are no children nearby during assembly, due to the risk of serious or fatal accidents. Dispose of the packaging
properly and do not allow children to play with the plastic that protect the equipment, due to the risk of suffocation.
•
The icons are intended to indicate the tools needed to assemble the equipment, the number of people and the way the bolts
are tightened.
TOOLS
SCREW TIGHTENING TORQUE
SPECIFICATION TABLE
ICONS
50%
Do not completely
tighten the screws
100%
Perform the final
tightening of the
bolts
For this assembly
it is recommended that
be made in three
or more people
Diameter [mm]
M6
Torque [N.m]
9-12
M8 22-29
M10
45-58
Allen
key
Thread lock
medium torque
Philips
screwdriver
Fixed wrench
Pliers for
elastic rings
ATTENTION!
The tower assembly is the same for both sides of the equipment.
To mount the other side simply follow the same steps as described in the
manual again.
Nivel
ATTENTION!
The Crossover equipment uses several bushings for the pulleys. To find out which bushing to use, follow a 1:1 template of
bushings comparison to know which one to use in a particular assembly step.
BUSH n°25 BUSH n°20
BUSH n°33
BUSH n°32
BUSH n°34