Corporate Headquarters:
1080 North 11th Street, San Jose, CA 95112 Phone: (408) 292-2214 Fax: (408) 292-2733
www.etorque.com
Page 38
F o r c e & L o a d S e n s o r s
Starting April 2007, PTT models can be used with Force & Load sensors.
Note:
Mountz PTT units with serial numbers that start with digits "07" and later feature a new firmware and hardware.
Only models with serial numbers 07-01-001 or later can operate with the Force & Load sensors. Prior PTT versions can-
not support the Bar Force & Load sensors. Firmware and revision data can be seen on initial power on of unit.
Customers with older PTT versions, can send their unit to our service department and pay for it to be upgraded to
operate with load & force sensors.
Using PTT 2000 as a Force Measurement Meter
The PTT recognizes standard or ARCII equipped force sensors (load cells). The active modes of operation for force are
TRACK & PEAK. Descriptions of these modes are found in this manual (see page 8).
ARCII equipped sensors incorporate a small chip that allows for automatic sensor recognition (see page 14). This feature
identifies the sensor, all calibration data and a calibration date reminder. This chip can be added to the connection cable
to enable the features of the ARCII technology.
The SET UP mode allows users to define how the PTT operates, including setting of the Clock. Three modes that are
irrelevant to Force are Angle, T+A Threshold and First Peak (these are Torque Only selections).
The PTT only supports 2 units of measure when connected to a force or lead sensor. Those units are kN or Lbf.
Force sensors can be used in 3 directions. Clockwise (Compression), Counter Clockwise (Tension) or Both can be
selected in the Setup mode. (See page 16) for setting direction.
The included software program Mountz Torquemeter Interface Program (MTIP) has functions for Tool Tests, Data
Logging, Sensor and Meter Calibration. For calibration of Force sensors, select the sensor type Force.
For Tool Test you can define a type of parameter criteria, including tolerance settings for a specific function. (See page
18 for setting up Tool tests). For questions related to Force use, please study the manual or you can call a Mountz
representative for assistance.
