Charging the Batteries
Always leave the TorqueMate® Plus turned on when charging the batteries. This allows the micro-
processor to monitor the charging cycle. The TorqueMate® Plus can be used while charging without
affecting torque accuracy. The unit will go into battery saving pause (PAUS) mode after 5 minutes with-
out use, but the batteries will still be charging.
• The microprocessor monitors the charging process of the batteries. Always keep the TorqueMate®
Plus turned on when charging batteries (the TorqueMate® Plus will continue to charge batteries while
in Paus Mode).
• The TorqueMate® Plus can be used while charging batteries.
• If the batteries are fully discharged, the TorqueMate® Plus may take a few minutes to power up after
being plugged into the AC adapter.
BATTERY STRENGTH
The TorqueMate® Plus battery pack should last up to 10 hours with normal use and maximum charge.
When the battery charge falls below a certain voltage the “B” icon will show on the display. At this point
you should plug the unit into the AC adapter or replace the battery pack with a freshly charged pack. If
the battery pack falls below a level that will effect accuracy it will automatically turn off.
CHARGING TIME
4 Hours Minimum
BATTERY CHARGER
115 volt to 12 Volt DC, 300 mAg, Center Pin Positive
Other Adapters available upon request.
BATTERY CHARGING KIT
Accessory item that can be purchased.
Includes a charger and two batteries.
Part Number: 771147
23
