Mountfield Multiclip 501SP, Operating Instructions Manual, Page: 19 / 21

Stop the engine and disconnect the spark plug lead before working on the machine. DO NOT TIP
THE MOWER FORWARD OR ONTO ITS SIDE AS THIS WILL FLOOD THE CYLINDER AND AIR FILTER
WITH OIL. To access the underside of the machine, lift the front wheels by lowering the handle
until it rests on the ground.
CUTTER BLADE
Examine the cutter blade regularly for wear or damage.
•
A slightly worn blade can be re-sharpened by your local dealer.
•
If the blade is damaged it should be replaced. Replacement blade kits
are available from your Mountfield stockist. If in doubt refer to your
dealer, or telephone 0845 600 2912. Blades must always be marked
81004146/0
CLUTCH (Figure 8)
•
Once or twice a year clean the area around the transmission and drive
belt.
•
Remove the guard (1) by unscrewing the screws (2) and releasing the
couplings (3).
•
Using a brush or compressed air carefully remove any grass and dirt
from aound the transmission and drive belt.
•
Always refit the guard (1).
ENGINE
An engine manufacturer’s Owner’s Manual is supplied with your mower.
Please read this, it provides detailed information on engine operation,
maintenance and battery care. Repair work other than routine maintenance,
should be carried out by an authorised dealer.
STORAGE
A little time spent on your mower after use will ensure many years of reliable mowing. To access the underside of the
cutter deck, ensure the spark plug lead is disconnected, then lift the front wheels by lowering the handle until it rests
on the ground. Do not tip the mower onto its side, as this will flood the air filter with oil.
MAINTENANCE
Figure 8
Figure 7
BEFORE EACH USE
•
Always ensure that the mower is in a safe working condition. Inspect the cutter blade for damage; check safety
devices and guards; check that all nuts, bolts and screws are secure.
•
Check the oil level as follows:
a)
Remove the oil filler cap and wipe the dipstick clean (Figure 7).
b) Insert the dipstick into the filler neck without scewing it down.
Remove the dipstick and check the oil level; oil should be at the MAX
mark. The oil tank capacity is about 0.55 litre or 18 fluid oz.
c)
If the oil level is low add Mountfield oil part number MX855 or a
SAE 10W-30 oil, to the upper limit on the dipstick. Do not overfill; the
oil level should not be above the FULL mark.
•
Fill the fuel tank with unleaded petrol. Do not overfill; the level should
be below the bottom of the fuel tank neck.
Figure 9
Check the clutch function:
•
•
•
•
Push the mower forwards and backwards with disengaged transmission.
Set the clutch control to the position and push themower until the
front wheels engage.
In this position, the spring (11) should be extended 6 mm from it’s
unloaded position to provide sufficient locking force in the transmission.
If the spring is not extended sufficiently, adjust the wirenipple (13) at the
handlebar.
•
•
First loosen the locking nut (12) and then adjust the nipple (13).
Set the clutch control to the position and check that the transmission
is disengaged by rolling the mower forwards and backwards.
18