Mountfield Levita PW 100, Operation Manual, Page: 10 / 44

4. NAME OF PARTS: (FIG. 1
、
FIG.2)
5. PRODUCT DESCRIPTION
PURPOSE

The high pressure cleaner is designed to clean vehicles, machines, buildings, facades, etc. in the
private sector.
AREAS OF APPLICATION

Never use the machine in potentially explosive areas under any circumstances!

The operating temperature must be between 0 and +40
℃ .

The machine consists of an assembly with a pump, which is encased in a shock absorbing
housing. For an optimal working position the machine comes with a lance and a non-slip handle
grip, whose shape and configuration comply with the applicable regulations.

Do not cover or modify the lance or the spray nozzles in any way.

The high pressure cleaner is designed to be used with cold or lukewarm (max. 60
℃ ); higher
temperatures can damage the pump.

Do not use water that is dirty, gritty or contains any chemical products, as these could impair
operation and shorten the life of the machine.

Accessories can be used to carry out work with foam cleaners, sand spraying.
6. ASSEMBLY

Position the washer as NEAR as possible to the water supply.

The washer must be used standing on a secure, stable, positioned as shown. FIG.2.

Fit the lance into the gun and rotating it until the two parts are completely locked FIG. 3.

Connect the gun to the high pressure hose FIG.4.

Connect the high pressure hose to the water outlet on the washer FIG.5.

Connect the water supply hose to female coupler FIG.6, then connect to the water inlet of the
washer. The supply hose must have an internal diameter of at least 13mm (1/2 in.) and must be
reinforced. The water supply must be at least equal to the washer delivery capacity.

NOTE: The machine not suitable for connection to the potable water main (FIG. 13).
WARNING
The intake water temperature must not exceed 40°C. The water supply must not exceed 0.7 MPa.
CAUTION
The washer must only be used with clean water; use of unfiltered water of corrosive
chemicals will damage the washer.

Push the motor switch to “OFF” position FIG. 8.
Check that the electrical supply voltage and frequency (Volt/Hz) correspond to those specified on the
washer rating plate. If the power supply if correct, you may now plug in the washer.
1. Handle 7. Cord hook 13. Water outlet
2. Spray gun 8. High pressure hose 14. Warning label
3. On/Off switch 9. Hose hook 15.Gun hook
4. Mid lance 10. Rating label 16. Spray lance
5. Water inlet 11. Detergent bottle 17. Trigger
6. Power cord 12. Wheel 18. Gun lock
8