6
To remove the pieces, gently flex the balsa sheets until the pieces fall out.
You may find that you need to carefully trim the extra pieces of wood that
originally held the piece to the sheet.
2.
Slide the 1/8” Lt. Ply former into position on the 1/8” Plywood crutch as shown below. It is a
fairly tight fit, so work it back into position a little at a time. Do NOT glue them together yet.
3.
Press the crutch from step 2 and the fuselage wing mount into the 1/8” balsa former as shown
below. Make sure the blind nuts are facing as they are in the image! It’s easiest to lay the
former on your table and press the crutch into the slots. Do NOT glue yet.
4.
Press the crutch onto the 1/8” Lt Ply F1 as shown below. Nope, no glue here either.
