19
19.
Test fit the bottom right wing sheeting and weigh down the wing as shown. Weigh the wing
down and secure the sheeting along the back of the spar with thin CA. Pick up the wing and
glue the rest of the lower sheeting into place along the front. The sheeting rests on top of the
1/16” leading edge and in front of the 3/16” leading edge parts. Make sure that the sheeting is
fully pressed onto the tabs on the ribs and sits flush with the 3/16” leading edge part.
20.
Weigh down the right side of the wing and make sure it is straight and flat. Test fit the top
wing sheeting. Start by gluing down the front of the sheeting with thin CA, with the back
sitting up slightly, as shown in the image below.
21.
You can glue the back of the sheeting with thick CA (if you’re fast), or white glue. If you use
white glue, weigh down the sheeting while it dries to make sure you get a good bond.
22.
Repeat steps 19 to 21 for the Left side of the wing.
