10
14.
Press the rear 1/16” sides into place with the “lasered” side of the part to the inside of the
fuselage, as shown below. BEFORE you glue anything, check to see if the pushrod exit slots
line up with the holes in the rear 3/32” former. If they don’t, you have the parts on the wrong
side. Secure the sides with thin CA.
15.
Install the 3/16” rear spine into the formers as shown below. Make sure it is fully seated and
secure it with thin CA.
16.
Press the 1/8” plywood landing gear supports into place as shown below. The “lasered” sides
should face to the inside of the fuselage. Clamp them, or otherwise make sure they are fully
pressed into place and against the sides while the glue is drying. If you’re fast, you can use
thick CA. If not, then use some 5 minute epoxy, spread thin.
