45. Glue the
1
16
" Ply WS4 parts into the
1
16
"
Balsa WS2 parts, using Thick CA. (Repeat 3
more times)
46. Glue WS2-WS1-WS2 with Thick CA,
using the holes to align the parts with
1
8
"
dowel. Make 2 of these assemblies.
This completes the main Wing and Wing
Parts construction.
SANDING AND FINISHING:
1. Sand the wheel pants to the profile shown to the right. Round the
top corners and then sand the entire wheel pant smooth with 320 grit
sandpaper.
2. Sand the leading edge of both wings round, as shown in the image
to the right.
3. Use a piece of
1
8
" Balsa with sandpaper glued to one side, to sand
the top and bottom fuselage sheets where they come together in the
slot for the Horizontal Stab, as shown in the image to the right.
4. Lightly sand the entire airframe, finishing with 320 grit sandpaper.
The smoother finish sanding you do, the better your covered airplane
will look.
5. Trim out the pieces of former F13 that are in the slot for the
Horizontal Stab.
Sand this area as
described in Step 3.
Trim this 'tab' off, as
described in Step 5.
35