41. Glue the
1
64
" Plywood aileron reinforcement strip to the A1 parts. Line up the rear edges and
the slots carefully. Make 2 RIGHT and 2 LEFT ailerons. One LEFT and one RIGHT are shown
above. If you build them right next to each other, you can make sure you make the correct sides.
42. Press the Aileron ribs in place, as shown below, but do NOT glue them yet. They are
1
16
" Balsa A3,
1
8
" Balsa A2, and
1
16
" Ply A4. Make sure they are fully pressed in and glue
them with Thin CA. (Repeat to make 2 LEFT and 2 RIGHT ailerons)
43. Press
3
32
" A5 in place. Make sure it is fully inserted and FLAT against the ribs. After
you make sure that the aileron is straight and FLAT, secure it with Thin CA. (Repeat to
make 2 LEFT and 2 RIGHT ailerons)
44. Sand the ailerons as shown in the above images.
34