Open Footrest
5. ATTACHING BUGGYPOD®
TO PUSHCHAIR
7. SETTING HEIGHT
8. OPENING FOOTREST
Hold the Buggypod® vertically against
the mounting brackets on the host
pushchair.
NOTE ! the mounting bosses (g) are
supplied un-tightened so can slide
along the connector bar (c).
Tighten the grub screws on the
mounting bosses with the supplied
small allen key
Slide both mounting bosses, one after
the other, over the 4 green buttons on
the mounting brackets, top and
bottom.
Ensure all 4 buttons are fully in place.
Each button should produce an audible
“click” when popping through the
mounting boss holes.
Make sure the connector bar and
Buggypod are running parallel with
the centreline of the pushchair.
Make sure that, when viewed from
the rear, the Buggypod®lite seat
is level to the floor.
6. BUGGYPOD® ALIGNMENT
4
5
If the angle of your pushchair chassis
prevents this (e.g. with some 3 wheel
pushchairs or those which narrow
at the front or rear), then you should
use the connector bar adaptor (d)
available separately from stockists
(see www.buggypod.com for a
compatibility list of pushchairs
known to require the connector
bar adaptor and Appendix A for
assembly instructions).
Check that Buggypod® wheel is in line
as far as possible with the pushchair
rear wheels.
If it is not, then adjust position of
mounting bosses (g) and hinge (ip)
by first loosening the grub screws,
then pushing the mounting bosses
and/or hinge as appropriate along the
connector bar until the wheel is
in line.
If it is not, adjust the leg height by
pulling back the black leg lock 5mm,
then turn down to open lock; then
shorten or lengthen the telescopi
leg as necessary. Release the leg
lock to let it snap back into place.
If it is not, adjust the leg height by
pulling back the black leg lock 5mm,
then turn down to open lock; then
shorten or lengthen the telescopic
leg as necessary. Release the leg lock
to let it snap back into place.
