12072020 /
MFG-13448
Align holes of
hopper top
, then press sides of
hopper bottom
until it
snaps snugly in place. Insert
bolt
through each hole, place
lock washer
on bolt and screw
wingnut
onto bolt until tight. Repeat for all 12 bolts.
Note: Failure to properly secure two halves can result in leakage.
Place hopper bottom flat on the ground, and
slide the three provided
angled leg brackets
into the
hopper
as shown.
Make sure to fully insert brackets as far as
you are able to ensure the strength of the feeder.
Angled
Leg
Brackets
Insert
two (2) leg sections
into each of the square leg brackets.
Tap leg sections into place to ensure tight fit.
Flip
hopper bottom
assembly upside-down so that all three (3)
legs are on the ground.
Hopper
Top
Bolt
Lock
Washer
Wingnut
Hopper
Bottom
DO NOT EXCEED
200 LBS OF FEED
Lid Stop
Lid
1/4”-20 x 1”
Phillips-head
Bolt
ASSEMBLE MOULTRIE 30-GALLON QUICK LOCK HOPPER
D
Connect
Quick-Lock feeder kit
to
assembled hopper as shown.
After completing hopper assembly,
install as many legs sections as are
needed for your application.
Fill with corn/feed.
Do not exceed 200 lbs.
Install
lid
by aligning handles with notches in
hopper top
. Twist until
lid rests flush against
lid stop
.
To install a
Moultrie game camera
or
Feeder Power Panel (sold separately)
,
thread included 1/4”-20 x 1”
Phillips-head bolt
upward through hole in
lid handle and tighten bolt. Lid will hold up to 3 devices.
2
1
Quick-Lock
Feeder Kit
Hopper
Align lugs and L-slots
Our Service Department will gladly answer any questions you have.
www.moultriefeeders.com/support
MFG-13448_Pro Hunter II_2020 Manual-ENGLISH_12-7-20_FINAL.indd 3
MFG-13448_Pro Hunter II_2020 Manual-ENGLISH_12-7-20_FINAL.indd 3
12/7/20 10:46 AM
12/7/20 10:46 AM
