DO NOT EXCEED 400 LBS
OF FEED IN 55-GAL FEEDERS
Quick-Lock
Feeder Kit
Quick-Lock
Adapter
NOTE: DO NOT LOAD FEEDER until it is standing up and in place (see Section E-4).
Belly Band
Ring
Bolt
Spacer
Lock
Washer
Nut
DO NOT EXCEED 200 LBS
OF FEED IN 30-GAL FEEDERS
Belly Band
Ring
ASSEMBLE WITH MOULTRIE QUICK-LOCK ADAPTER
D
55-Gallon or 30-Gallon Barrel*
a. Assemble
Quick-Lock adapter
by snapping
bolt tabs
in place as shown.
b. Turn the
metal drum
upside down and slide the
belly band ring
around perimeter and make sure that belly band is snug against
the bottom structure ring as shown (Moultrie barrel only).
c. Slide the bolt through the
belly band ring
,
spacer
and
lock washer
as shown. Tighten nut on bolt until metal
belly band ring tabs are touching spacer on each side.
d. Mount
Quick-Lock adapter
using (3) 1/4” x 1” bolts, nuts and
washers provided in the pre-drilled holes (Moultrie barrel only).
Or use the Quick-Lock adapter as a template to mark and drill
the mounting holes (non-Moultrie barrel).
e. Connect
Quick-Lock feeder kit
to assembled adapter as shown.
*Can also be used on a 6.5-gallon bucket.
Assembled
Quick-Lock
Adapter
Bolt Tabs
ADJUSTING FUNNEL HEIGHT
C
ATTENTION:
Make sure the electric varmint guard is turned OFF and
battery is disconnected before adjusting funnel!
Once the funnel is in desired position,
retighten the screw with Phillips-head
screwdriver.
Do not over-tighten.
To adjust funnel height:
With a
Phillips-head screwdriver
,
loosen screw.
With screw loosened, use tabs to position funnel
in one of the two positions by either pushing
down or up depending on desired position.
Barrel cut-away for clarity.
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
For devices approved under Part 15, the user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user about changes or modifications to the device (Section 15.21).
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
MFG-13265_NXT Hunter QL_Manual-ENGLISH_11-25-20.indd 2
MFG-13265_NXT Hunter QL_Manual-ENGLISH_11-25-20.indd 2
11/30/20 11:33 AM
11/30/20 11:33 AM