9
-
With the deep filled sandwich plates (H) or
the toasted sandwich plates (I)
, butter the
outer surface of the slices of bread.
Once the appliance reaches the right tempe-
rature, the green light
(E)
comes on. Then
place the slices of bread on the lower plate.
With a spoon, lightly push down on each
slice to form a slight recess into which you
can add the sandwich filling.
Cover the filling with the second slice of
bread, then close the appliance slightly, until
you can close the lock.
-
With waffle plates (J)
, lightly oil the hotpla-
tes.
Once the green light
(E)
comes on, pour the
waffle batter slowly making sure to cover the
lower plate but without spilling over.
Bring the top part down. The back hinge will
have a little extra give, to provide extra space
for the waffle batter to rise.
Use of the timer (C)
(according to model)
- The timer enables you to monitor the cooking
time.
To set the timer:
- Press the button situated on the right side of
the screen (either several short presses or
hold down the button) to set the time.
Note: in case of an error, continue pressing
the button. The timer comes automatically
back to 0 after the figure 9.
- Release the button. After 5 seconds, a black
dot flashes at the right of the set figure and
the time deduction starts.
To delete the setting of the timer:
- To stop the timer during the time deduction,
hold the button situated on the right side of
the screen down for 2 seconds: the timer is
automatically reset to zero and the light goes
out after about 1 minute.
To stop the warning signal:
- When the cooking time is finished, the timer
gives a warning signal and stops automati-
cally after 20 rings.
- To stop the warning signal manually, press on
the button situated on the right side of the
screen. The timer light goes out after about 1
minute.
- Warning: the timer indicates the end of cook-
ing but does not turn the appliance off.
- Never let the mains lead touch the hot surfa-
ces of the appliance, or any heating source.
Before each use, check the lead is not
damaged, and never let it hang within reach
of children.
Important
: If the mains lead or the plug are
damaged, do not use your appliance. In order
to avoid any accident, they must be replaced
by an approved Moulinex Centre (see list in the
leaflet “Moulinex Service”).
- Position the appliance on a flat, heat resist-
ant surface.
- Do not leave or use the appliance in a damp
area.
- Always disconnect after each use and wait
for the appliance to cool down before handl-
ing. Never immerse the appliance in water.
- Do not touch the non-stick hotplates when in
use.
- Only Moulinex non-stick hot-plates should
be used.
- If the appliance is damaged, or it will not
work, consult a Moulinex approved service
centre. (See list in Moulinex Service booklet).
Changing of the plates
- Unplug the appliance.
- Check the appliance is cool.
- Open the appliance.
- To remove the plates: press the button
(G)
to
unlock the cooking plate and remove the
plate lifting it at an angle.
- To put the plates back in position: put the
plate at an angle on the appliance, into the
two notches situated opposite the button
(G)
, then press on the plate until it is locked.
Before using your appliance
for the first time
- After lightly oiling the hot-plates, close the
appliance and plug it in. The red light
(D)
comes on.
- Leave for a few minutes to allow the “new
smell” to disappear.
- Once the appliance reaches the right tempe-
rature, the green light
(E)
comes on.
Using the appliance
- Plug the appliance in. The red light
(D)
comes on.
1
1
3
1
1
3
AMD 1, 2 & 3 24/07/02 9:12 Page 9
