Motus Scooty 8,5, User Manual

Page: 13 / 74

13
BAR ADJUSTMENT
If you feel that the bar is not tight enough, use the hex wrench to tighten the
two screws in the folding mechanism
INFLATION OF WHEELS
If you notice that you need more air pressure in the wheels, use an inflation
system to adjust the pressure. CAUTION: Excessive pressure could cause the
wheel to burst. The driving with no air in wheels also can damage the wheel.
4.2 Starting of a ride
Prior to usage, make sure the folding mechanism has been fully secured.
Step 1. Start the vehicle, pressing the power button (Drawing 1B: D). It will be
ready to use in a while.
Step 2. Place your feet properly down on the platform. Move to activate the
scooter and press the acceleration trigger. Drive the vehicle, maintaining the
gravity center so to keep the balance. It is to be remembered not to move
your body in an abrupt manner.
Step 3. To accelarete press the trigger lever (Drawing 1A: B) down.
Step 4. To brake, press the trigger lever (Drawing 1A: E) down.
Step 5. Getting off the vehicle: prior to stepping down, the vehicle needs to
come to a halt.
4.3 Terrain and Reminders
1. It is intended for indoors or use on smooth, flat surfaces. However, to pre -
vent loss of traction, you must always be careful when riding and learn to
identify and avoid slippery and wet surfaces, loose materials, slopes, potholes
and other obstacles.
2. Stop and step off it over unsafe surfaces or terrain.
3. Their wheels must be able to grip the ground for you to stay upright. Slips
occur when loses traction, potentially causing loss of control and a fall. Abrupt
maneuvers and riding over slippery surfaces, bumps, and loose objects and
materials, may cause it to lose traction.
4. Keep in mind that the maximum distance traveled on one full battery
charge shortens as the user’s weight increases and the slope of the terrain. It
also depends on the surface conditions and weather conditions.
5. MAINTENANCE & WARRANTY
5.1 Storage
Please store it in a dry place. If left unused, recharge and unload the battery
every month to maintain longevity of the battery.
5.2 Cleaning
To clean the device, use a damp cloth. If you need to scrape dirt, use a soft
brush and then a damp cloth. In case the dirt is very sticky you can use a little
toothpaste. Remember to wipe with a damp cloth after this.
Be sure to keep the skid off while cleaning and make sure you cover the
charging port to avoid problems with the electronic components.
Do not use alcohol, gasoline, kerosene or other volatile or corrosive chemical
components. This can damage both the appearance and the internal struc -
ture of the scooter. Also, do not use a pressure water gun or running water.
5.3 Warranty
The warranty will not be covered under the following conditions:
1. Malfunction due to misuse.