Motus Scooty 8,5, User Manual

Page: 12 / 74

12
Drawing 3B: Folding and transportation
Before folding, make sure the device is off, open the locking lever, bend the
skate and hook the handlebar part to the rear fender hook.
Once folded hold the by the bar to transport it as indicated in the figure. To
avoid the risk of back fender demage uphold the scooter underdeck.
3.2 Charging the Battery
The packaging included a built-in lithium-ion battery. For the first time, you
must fully charge the battery. Be sure to charge the battery in a clean, dry
location.
Plug one end of the power cord into it. Plug the other end into a grounded AC
outlet. Do not disconnect the charger until the battery has been fully loaded.
Ones the charging is done, remember to close the lid.
Avoid completely discharging the batteries, it is better to charge them while
there is still power in them.
It is forbidden to disassemble the battery compartment. Only its manipula -
tion in Official Technical Service of producer.
3.3 Your Weight Must Be over 45 kg
In order to guarantee your children’s safety, everyone who drives must be
over 45kg in weight. If the driver’s weight is lower than 45kg, the vehicle may
work improperly.
3.4 Battery Level
Battery level is displayed in the place, marked with the letter C in the Drawing
1B.
Sustained range will decrease during winter, because the battery perfor -
mance decreases quickly in cold conditions. In -15 ° , for example, battery per -
formance is only about half in comparison to that in room temperature. To
ensure battery life during the winter, it must be charged and unloaded at
least once a month.
WARNING: It will notify you when the battery level is critically low by slowing
down and shaking the wheels when you are riding it, if these warnings occur,
immediately slow down and safely step off. Turn the unit off. Do not attempt
to ride again until the battery is recharged.
4. RIDING GUIDE
4.1 Preparation
When you want to start your first ride, please try to wear comfortable casual
or sports outfit and wear flat shoes. Please bring it to a more spacious place,
and ensure that there aren’t any significant obstacles. It is advisable to wear a
safety gear to insure risk against accidents.
BRAKE ADJUSTMENT
JIf you feel the brakes are too tight, use the hex wrench counterclockwise to
loosen the screws on the pressure plate on the disc brake seat. Release the
brake line to shorten slightly the exposed length and tighten the screws of
the pressure plate. If you feel that the brake is too loose, release the screws on
the pressure plate, drag the brake cable to slightly lengthen the length and
then lock the screws on the pressure plate.
EN